Wallpaper Calculator

By HomeAdvisor

Updated July 23, 2019



Area 1 (in ft.)
Area 2 (in ft.)
Area 3 (in ft.)
Area 4 (in ft.)

Tips on Measuring for Wallpaper

Before you begin, take the room measurements in the list below – round to the nearest foot.

1. Wall Height
Measure from floor to ceiling.

2. Wall perimeter for areas you plan to wallpaper
Measure the length of each wall. Add all lengths together to obtain the total horizontal distance, or perimeter.

3. Sloping walls
Sloping walls form a triangular wall space. To calculate a triangle’s square footage, multiply the length of the wall at the base of the triangle by its height and divide by 2.

Homeowner Tip – Wallpaper is sold in individual rolls, or two or three rolls to a package. Each standard American roll gives you about 35 square feet. Allowing for trimming and waste, the usable amount in each roll generally comes to 27 square feet. This figure also takes into account waste resulting from the drop pattern. This is the distance one section of new paper must be dropped to match the pattern on the panel just installed. To eliminate this concern and save paper, use two rolls at a time and alternate.

Wallpaper is identified not only by its pattern number but also by a number that is variously called a lot, batch, or run number. This number shows that an entire print run was made in that color, which indicates that the color is consistent. The same color in a subsequent run with a different lot number may be noticeably different. When buying wallpaper, purchase more than you need of the same lot number so you can match colors later for repairs or additional papering. Save excess for future repairs or for shelf and drawer liners.

Ready to start your Wallpaper Installation?
Find Pros


  1. Harold Stith, September 7:

    I want to cedar panel a closet that’s 5 feet long x 2 feet x wide x 8 feet high. How many box’s (15 square feet each) will I need.

Are You Familiar With This Topic? Share Your Experience.

Compare quotes from local pros Compare Quotes
Return to Top